Connect Water Supply Line - Norcold Polar 10 Serie Manuel D'installation

Connect the Ice Maker (N10LXIM, and NA10LXIM models)
The ice maker is assembled to the refrigerators at the factory as optional equipment. If the refrigerator does not have a factory installed
ice maker, one can not be added to the refrigerator at a later time.
The refrigerator installer must connect a cold water supply line to the solenoid valve at the rear of the refrigerator. The following are
necessary to connect the ice maker:
- 1/4 in. OD copper tubing for the water supply line.
- 1/4 in. OD plastic tubing for the water supply line.
- 1/4 in. shut off valve in the water supply line. This should be easily accessible through the lower intake vent.
Connect the water supply line:
Install a 1/4 in. OD water supply line [43] from the water shut off valve of the vehicle to the
solenoid water valve [44] at the rear of the refrigerator (See Art 01014):
A brass compression nut [45], a brass sleeve, a plastic sleeve [46] , and a
NOTICE
brass insert [47] are supplied and attached to the rear of the refrigerator (See
Art 01755).
- Put the compression nut and then the sleeve onto the water supply line [43].
- For copper tubing, use the brass sleeve.
- For plastic tubing, use the plastic sleeve [46].
- For plastic tubing with .040 in. wall thickness, also use the brass insert [47].
- Flush the water supply line until the water is clear.
- Put the tubing into the water valve until it is against the stop of the adapter.
- Tighten the compression nut by hand (hard finger tight).
- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.
- Open the water shut off valve of the vehicle.
- Examine the connections for leaks.
OR
44
48
43
45
Art 01014
45
46
47
ART 01755
Installation Manual 15
43