How To Froth Milk For A Cappuccino Or Latté - Breville Die Cast Serie Mode D'emploi

felt, this will be at an approximate 90°
angle to the machine.
STEP 7 - BREWING THE COFFEE
• The red 'Heating' light cycles off when
the machine has reached the correct
temperature for brewing.
• Ensure the Drip Tray and Grid are in
place.
• Place one or two pre-warmed cups
beneath the Filter Holder outlet.
• Set the Selector Control to the
'Espresso' position.
• After a few seconds, aromatic coffee will
begin to brew into the cups. A pumping
noise will be heard in this operation.
• When sufficient coffee has flowed into
the cups, set the Selector Control to the
'Standby' position. This will stop the flow
of coffee.
• If the steam function is not required,
STEP 6 – INSERTING THE FILTER HOLDER
leave the Selector Control to the
• Place the Filter Holder underneath the
'Standby' position, unplug the power
Brew Head so that the handle is aligned cord and allow the machine to cool.
with the insert graphic. Insert the Filter
Holder up into the Brew Head and rotate
the handle to the right until resistance is
OPERATING YOUR BREVILLE DIE CAST SERIES ESPRESSO MACHINE
1 6
PRE-BREW FUNCTION
• When the Selector Control is set to the
'Espresso' position, the 15 bar pump
pumps water momentarily, followed by a
pause, then continues to pump the
water through to the ground coffee in
the Filter Holder. This pre-brew function
is an advanced feature of the 800ESXL.
The ground coffee is moistened by a
small amount of water before full
extraction. The ground coffee expands
and when greater pressure is built up,
the brewed coffee is extracted with its
f u l l f l a v o r .
HOW TO FROTH MILK FOR A CAPPUCCINO OR LATTÉ
STEP 8 – EMPTYING THE FILTER HOLDER
• Remove the Filter Holder from the Brew
Head by turning the Filter Holder to the
left until it releases. Turn the Filter
Holder upside down to empty the used
coffee (used coffee grounds should be
thrown away and not put down the sink
which may block drains). Remove the
Filter by using the indents on the side of
the Filter Holder. Rinse the Filter and
Filter Holder with water and allow to dry.
CAUTION: THE METAL PARTS OF THE FILTER HOLDER MIGHT STILL
BE VERY HOT. COOL THESE PARTS IN COLD WATER.
The Die Cast Series Espresso Machine
comes complete with a Commercial Swivel
Steam Wand and Stainless Steel Frothing
Attachment. When using the Frothing
Attachment a large amount of froth is
easily created.
If less froth is required, remove the
Frothing Attachment and steam the milk
using the Steam Wand. To remove the
Frothing Attachment, ensure it is cool then
simply pull down and remove. The Frothing
Attachment can be stored in the Storage
Tray inside the machine if not used
regularly.
To refit the Frothing Attachment ensure it
is securely attached to the Steam Wand by
inserting it, from either end opening, onto
the Wand and pushing firmly upwards onto
the rubber surround. Ensure the fine steam
holes on either end of the Frothing
Attachment are clean to achieve optimal
frothing.
• The first step in making a cappuccino or
latté is to make a short espresso. Refer
to "Operating your Breville Die Cast
Series Espresso Machine" on Page 12.
• Then fill the stainless steel frothing jug
HOW TO FROTH MILK FOR A CAPPUCCINO OR LATTÉ
1 7