CLEANING THE FILTERS, FILTER HOLDER
AND BREWING HEAD
•
Soak the tip in hot water before using
•
The stainless steel Filters and Filter
the pin on the Cleaning Tool to unblock.
Holder should be rinsed under water
Replace the tip back onto the Steam
directly after use to remove all coffee
Wand and secure with the Cleaning Tool.
particles. Should the fine holes in the
filters become blocked, the fine pin on
the Cleaning Tool can be used to clear
the holes.
•
The Brew Head interior should be wiped
with a damp cloth to remove any ground
coffee particles.
•
Periodically run water through the
machine with the Filter Holder in place,
but without any ground coffee, to rinse
out any residual coffee particles.
CARE AND CLEANING
2 6
CLEANING THE OUTER HOUSING /
CUP WARMING PLATE
•
The outer housing and cup warming
plate can be cleaned with a soft, damp
cloth (do not use abrasive cleansers,
pads or cloths which can scratch the
surface).
CLEANING THE DRIP TRAY
•
The Drip Tray should be removed,
emptied and cleaned at regular intervals,
particularly when the Drip Tray Full
NOTE: Do not clean any of the
Indicator is showing full.
parts or accessories in the
•
Remove the Drip Tray Full Indicator and
Grid from the Drip Tray, wash with warm
soapy water, using a non-abrasive
washing liquid, rinse and dry thoroughly.
•
If further cleaning is required the full
indicator can be removed from the drip
tray by releasing the side snaps.
CLEANING THE STORAGE TRAY
•
The Storage Tray can be removed after
the Drip Tray is removed then cleaned
with a soft, damp cloth (do not use
abrasive cleansers, pads or cloths which
can scratch the surface).
CAUTION: DO NOT IMMERSE CORD, PLUG OR APPLIANCE IN WATER
OR ANY OTHER LIQUID.
THE WATER TANK SHOULD NEVER BE REMOVED OR
COMPLETELY EMPTIED DURING DECALCIFYING.
DECALCIFYING
•
After regular use, hard water can cause
mineral build up in and on many of the
inner functioning components, reducing
the brewing flow, power of the machine,
and affecting the quality of coffee.
•
We advise decalcifying the machine on a
regular basis (every 2-3 months) using a
liquid decalcifying agent. Follow the
instructions provided, or use the
following
as a guide:
Diluted solution (for softer water)
•
1 part decalcifying agent
•
2 parts cold tap water
Concentrated solution (for harder water)
•
1 part decalcifying agent
•
1 part cold tap water
NOTE:The stainless steel Filters
should not come in contact
with any decalcifying
agents.
Do not use powdered
CARE AND CLEANING
2 7