Bartscher Bain-Marie 288.301 Mode D'emploi page 28

Installation
Installation operations, gas or voltage conversions to other than the original, starting up the
installation or appliance, ventilation, letting out fumes, and maintenance must be done following the
manufacturer's instructions and observing the norms in force, by qualified personnel, in compliance
with the following provisions (GB):
Gas Safety (Installation and Use) Regulations, 1984
Health and Safety at Work Act, 1974
Codes of Practice, BS6173, 1982
The Building Regulations, 1985
The Building Standards Regulations, 1981
For others countries follow the relevant local rules for:
Gas board rules
Building regulations and local fire prevention provisions
Safety norms in force
Provisions of the Gas supplying company
The Electrical Norms in force
The Fire Brigade rules
Fume evacuation
It is not necessary to connect these Type "A1" appliances directly to an evacuation pipe for
combustion products. The products of combustion, however, must be directed into suitable hoods or
similar devices, connected to a reliably efficient chimney, otherwise directly outside. Failing this
the use of an extractor fan is permitted connected directly to the external environment with a
capacity no lower than that stated in table1. This value must be increased with the air exchange
necessary for the well-being of the operators, in accordance with the norms in force. (approximately
3
a total of 35 m /h per kW of gas output installed).
INSTALLATION
Preliminary operations
Remove the appliance from the packaging, ascertaining that it is intact and, if in doubt, do not use it
but call in professionally qualified personnel. After having verified that the appliance is in good
condition, the protective film may be removed. Carefully clean the external parts of the appliance
with warm water and detergent using a cloth to remove all remaining residues and then dry it with a
soft cloth. If there are still traces of glue residues, remove them by using a suitable solvent (e.g.
acetone. For no reason use abrasive substances. After having been put into place, the appliance
must be levelled by regulating the adjustable feet.
26