Bartscher Bain-Marie 288.301 Mode D'emploi page 34

SUBSTITUTING COMPONENTS
ATTENTION! Before carrying out any substitutions, make sure that the appliance is
disconnected from the electric mains and that the gas cut off valve is closed.
Safety thermostat (fig. 8-17, pag. 4, 5)
To substitute the thermostat remove the knobs, the drain tap lever and the control panel as in fig. 8.
Then remove the bulb support. To substitute the tap, it is necessary to remove the knobs and the
control panel. Then unscrew in sequence the pipe union of the piping, which leads to the burner (1),
the pipe union of the piping of the pilot burner (2), the thermocouple (3) and finally, the pipe union
of the ramp (4). Then substitute the part.
Thermocouple
To substitute the thermocouple of the double boiler, remove the knobs, the drain tap and the control
panel. It is then necessary to unscrew the fitting of the thermocouple on the tap and the one on the
pilot unit, then substitute the part.
Heating elements (fig. 8-18, pag. 4, 5)
To substitute the heating elements remove the knobs, the drain tap lever and the control panel as in
fig. 8, Then it is necessary to unscrew the fastening screws (1) of the heating element (2) to be
substituted, disconnect it from the cabling, remove it and then substitute it.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! In the event that components of the gas installation have been substituted, it is
necessary to check for tightness and the correct functioning of the various parts.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
32