Bartscher Bain-Marie 288.301 Mode D'emploi page 32

Gas Bain Marie
(fig. 13, pag. 5)
To light the double boiler burner, proceed in the following way:
- turn the knob (1) from the off position
- press down the button hard;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the hole in the control panel;
- light the main burner, positioning the knob on one of the eight possible positions, choosing the
one most suited to the type of cooking desired, noting that they correspond approximately to the
temperatures shown below:
P o s iz io n e [N °]
T e m p e r a tu r a [°C ]
To switch off the main burner, it is necessary to turn the knob to the right to the on position (
switch off the pilot, turn the knob again to the off position
Electric Double Boiler (fig. 14, pag. 5)
To heat a double boiler vat, proceed in the following way:
- Turn the thermostat knob (1) to the position of the required heating temperature; the two pilot
lights switch on, the green one stays on to show the presence of tension while the orange one
goes out as soon as the vat reaches the correct temperature.
- To switch off, turn the knob into the 0 position.
Vat Filling (fig. 15, pag. 5)
First of all ensure that the drain tap is tightly closed, having done this turn the water load knob
anticlockwise (1), fill the vat to the marked level.
Vat Draining (fig. 16, pag. 5)
To drain the vat it is necessary to turn the lever on the control panel (1) anticlockwise.
At the time of draining, make sure that the appliance is not working.
ATTENTION! Only use the appliance under surveillance. Never heat up an empty vat.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
INSTRUCTIONS FOR USE
to the on position
1 2 3
4 5 5 0 5 5
30
;
to light the pilot burner;
4 5 6
6 0 7 0 8 0
.
7 8
8 5 9 0
), to