Weighing-In Using Deltadisplay - Mettler Toledo PE360 DeltaRange Mode D'emploi

OPERATION: How to weigh in
Weighing-in means filling loose or liquid objects into a container on the balance until a desired weight (the target weight) has been reached.
PE balances are equipped with DeltaDisplay which makes it easier to weigh in because, when fast weight changes occur, the last number of the display is temporarily
blanked out.
15
1
Weighing-in
– Place the container on the weighing pan.
– Tare by pressing control bar (1): the balance
displays zero.
– Fill in objects to be weighed up to the desired
target weight.
Note: While weight is changing in the display, the
stability detector lamp (15) is on. It only goes off
when the result is stable.
10
15 16 17
Reading results
While filling in steadyily, pay attention to the first two
digits (16) only until in the range of the target weight.
While filling in very slowly towards the target weight,
pay carefully attention to the digits to the right (17).
When weight is increasing quickly, the last digit (18)
blanks out temporarily; when weighing in slowly,
this digit reappears, so far as the fine range has not
been exceeded.
18
Weighing in several components
If several components must be weighed in, one after
the other, each weighing can be tared out and the
next weighing can proceed again from zero and with
the fine range readability, until the combined weight
of container and objects reaches the end of the
weighing range:
– in the PE360:
– in the PE3600:
360 g
3600 g