IMER RD 75 Manuel D'utilisation page 47

Please keep to the following procedure before storing your pump for at least 30 days:
1. Drain the water circuit (see 10.1.);
2. Replace used oil with new oil (see 9.1.);
3. Drain the fuel system (see 10.2.);
4. Disconnect the battery cables;
5. Clean the pump using an oil-soaked cloth;
6. Pull the starter rope until you feel it is difficult (engine compression so that the valves are closed
to prevent any oxidation) then leave the engine in this position;
7. Store the pump in a well ventilated, clean and dry room.
10.1. EMPTYING THE WATER CIRCUIT
1. Unscrew the drain plug and empty completely the pump body [Fig. 29 or Fig. 30];
2. Remove the priming plug [Fig. 13];
3. Clean the pump body with clear water;
4. Allow water to drain completely;
5. Replace the priming and drain plugs.
10.2. DRAINING THE FUEL CIRCUIT
■ Avoid this operation near heat source, flame or spark may cause a fire.
■ Do not smoke.
1. Place a container under the fuel tank to catch the fuel;
2. Unscrew the fuel tank and remove it to facilitate access;
3. Remove the fuel tank cap [Fig. 06];
4. Remove the fuel tank drain plug wich is located under the fuel tank [(b) Fig. 34];
5. Drain all the fuel;
6. Replace the drain plug and replace the fuel tank cap.
■ Wipe spilled fuel before starting the engine.
WARNING
F
EN
E
R
47