Battery Preparation - IMER RD 75 Manuel D'utilisation

RD 75 / SWT 75 D / SWT 120 D / JET 100 D
NOTE
Do not forget to fit a filter on the filling hole before topping up with fuel [(B) Fig. 07] to prevent dust,
dirt or any other foreign bodies from getting into the tank.
□ Carefully wipe off the fuel spilt on the ground before starting the engine.
RECOMMENDED FUEL (DIESEL)
Automobile Diesel fuel to following standards, do not use heating fuel and domestic fuel:
Union european
International
USA
England

3.5. BATTERY PREPARATION

Your pump set is equipped with an electric start. The battery is not charged and dry, which means
that it can be put into service immediately after being filled with acid. But it is better for longevity and
performance of the battery, to charge it slowly.
1. Remove the degassing plug;
2. Connect the degassing hose to the outlet fitting;
3. Unscrew the filler plugs;
□ For your saftey wear gloves and protection glasses.
4. Fill the electrolyte up to the maximum level indicated on the battery ;
5. Leave the battery at rest for 1 hour before charging. If during this time the level of the electrolyte
has dropped, complete the level;
NOTE
Load the battery with filling plugs unscrewed.
6. Charge the battery;
7. Replace the plugs;
8. Clean the electrolyte that has leaked out on the battery;
9. Connect the red cable to the positive (+) terminal of the battery and the black cable to the
negative (–) terminal.
Fuel tank capacity (DIESEL)
WARNING
EN590:96
ISO 8217 DMX
No. 2-D, No. 1-D, ASTM D975-94
BS 2869-A1 or A2
WARNING
13 L
37
F
EN
E
R