Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
I N S T A L L A T I O N
C O N T.
Figure 10
strength grade weaker than ISO
grade 8.8.
When attaching wires to the motor
terminals and solenoids (relays),
hold the inner nut when tightening
the outer nut. Do not allow the
motor terminals to rotate for it may
cause internal wire breakage or
part misalignment. Be especially
careful in preventing the solenoid
(relay) terminals from rotating. Any
rotation can damage the solenoid
(see Figure 11).
Figure 11
Step (3)
Disconnect the vehicle battery
leads.
Motor
Solenoid
Assembly
Do not sub-
stitute any
Remote
Switch
Receptacle
Green
Black
gasses which are flammable and
explosive. Wear eye protection
during installation and remove all
metal jewelry. Do not lean over
battery while making connections.
Figure 12
Step (4)
Route the two (2) wires through
the vehicle grille to the battery. To
ensure against insulation abrasion
and/or cutting, apply several layers
of electrical tape where wiring may
come in contact with sharp metal
parts of the vehicle. Attach the cir-
cuit breaker assembly to the end of
the red terminated wire. Wrap the
circuit breaker assembly with elec-
trical tape to prevent accidental
short circuits.
Black
White
Red
Circuit Breaker
Automobile bat-
teries contain
Be Prepared
9
Publicité
Table des Matières
