Installation; Installation Conditions; Compressor Assembly - EKOM DK50 4VR/50 Manuel De L'utilisateur

INSTALLATION

INSTALLATION
Risk of incorrect installation.
Only a qualified technician may install the compressor and place it into operation
for the first time. Their duty is to train operating personnel on the use and
maintenance of the equipment. An entry is made in the equipment installation
record to certify installation and operator training. (see the Annex chapter)

10. INSTALLATION CONDITIONS

 The compressor may only be installed and operating in dry, well-ventilated and clean
environments under the conditions specified in the Technical Data chapter.
Risk of damage to the device.
The equipment may not be operated outdoors or in otherwise wet or damp
environments.
Risk of explosion.
Do not use the equipment in the presence of explosive gases, dust or
combustible liquids.
Burn or fire hazard! Caution! Hot surface!
Portions of the air pump may be hot and reach hazardous temperatures during
compressor operation that may harm materials or operating staff.
 The compressor must be installed so that it is accessible at all times for operating and
maintenance. Please ensure that the nameplate on the device is readily accessible.
 The compressor must stand on a flat, sufficiently stable base (be aware of the weight of the
compressor, see the Technical Data chapter).
 Any other use or use outside this framework is not considered as intended use. The manufacturer
is not responsible for any damages arising from such use. The operator/user assumes all risks
High temperature hazard.
The placement of air flow impediments upstream or downstream of the cooler is
prohibited. The temperature of internal and external parts of the cooler may be
hot and reach hazardous temperatures.
You may notice a "new product" odour when you first place the product into
service (for a short period of time). This odour is temporary and does not impede
the normal use of the product. Ensure the space is properly ventilated after
installation.

11. COMPRESSOR ASSEMBLY

11.1. Handling and releasing the compressor
 Unpack the compressor from the packaging.
 Position the compressor at the site of installation. (Fig. 4)
Use the handles on the compressor to move the compressor as needed. Do not
use other parts of the compressor (the air pump, etc.) for grip
At least two persons are needed to handle the equipment.
01/2022 25 NP-DK50 4VR 50, DK50 2x4VR 110-MD-6_01-2022