Chapter 4: Accessories Installation; Figure 17: Location Of The Rear Accessory Connector - Motorola WAVE Mobile TLK 150 Garantie Et Guide D'installation

Masquer les pouces Voir aussi pour WAVE Mobile TLK 150:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MN006372A01-AF
Chapter 4 : Accessories Installation
Chapter 4
Accessories Installation
The accessories must be installed through the rear accessory connector that is located on the rear of
the radio, adjacent to the power connector.
Connect approved TLK 150 accessories to the rear Mobile Accessory Port (MAP) connector through
16-pin MAP connector kit (HLN9457_ ). The accessory connector block protects the pins from short
circuit. Most of the Motorola Solutions-approved accessories are supplied with female terminals
specifically designed to fit the accessory connector block.
Insert the accessories' female terminal into the appropriate location on the accessory connector block
as shown in Pin Configuration of Rear Accessory Connector (as viewed from the rear of the radio).
Turn off your radio and disconnect the power cable. Connect the accessory connector block to the rear
MAP connector. Ensure all accessories and cables have been securely connected. Finally, connect the
power cable.

Figure 17: Location of the Rear Accessory Connector

Label
1
26
1
Description
Rear Mobile Accessory Port (MAP) Connector

Publicité

Table des Matières
loading

Table des Matières