Getting Ready To Play; Connecting The Clip To The Wavedrum Mini; Connecting The Power; Turning The Power On - Korg WAVEDRUM mini sondius xg Manuel D'utilisation

Getting ready to play

Connecting the clip to the WAVE-
DRUM Mini
1. Make sure that the WAVEDRUM Mini's power
switch is turned off. (The display and indicators
should be unlit.)
2. Connect the clip to the CLIP jack located on the
left side of the WAVEDRUM Mini.
Sensor clip (Clip)
Do not connect anything other than the
included clip to the CLIP jack.
3. To prevent the clip cable from being unplugged,
use the cable hook located on the bottom of the
WAVEDRUM Mini to secure the cable in place.
CLIP jack
Cable hook

Connecting the power

1. Connect the DC plug of the included AC Adapter
to the DC9V jack located on the right side of the
WAVEDRUM Mini.
2. Plug the AC Adapter into an electrical outlet.
Power switch
DC9V jack
Use only the included AC Adapter. Using any
other AC Adapter may cause malfunctions.
Use an AC outlet of the correct voltage for the
included AC Adapter.
3. To prevent the AC Adapter cable from being
unplugged, use the cable hook located on the bot-
tom of the WAVEDRUM Mini to secure the
cable in place.
Cable hook

Turning the power on

1. Lower the volume by turning the VOLUME
knob all the way to the left.
2. Press the power switch to turn the power on.
Getting ready to play
AC adapter (included)
to an electrical outlet
7