Controls; Safety Instructions; Igniting And Adjusting - ETNA A026VWRVS Notice D'utilisation

YOUR GAS HOB
What you should pay attention to
• Ensure that there is adequate ventilation during use.
º Keep natural ventilation openings open.
º When using the hob for long periods, extra ventilation is
necessary. Open a window for instance or install a mechanical
fan.
• Use the hob only for preparing dishes.
º The appliance is not suitable for space heating.
• Never flambé under an extractor hood.
º The high flames can cause a fire, even if the fan is switched
off.
• The burner parts are hot during and immediately after use.
º Do not touch them, and avoid contact with non-heat-resistant
materials.
º Never immerse hot burner parts in cold water. The rapid
cooling can damage the enamel.
• The distance from the pan to a knob or non-heat-resistant wall
should always be greater than two centimetres.
º In the case of smaller distances the high temperature may
cause the knobs or wall to discolour and/or distort.
• Always use the pan supports and suitable cooking utensils.
º Always place the pan on the pan support. Placing the pan
directly on the burner head can result in dangerous situations.
º Aluminium trays or foil are not suitable as cooking utensils.
They can become burnt into the burners and pan supports.
• Installing burner parts and pan supports.
º The hob can only function effectively if the burner parts have
been assembled using the guide ridges.
º Ensure that the pan supports lie properly against each other
and flat on the drip tray. Only then can the pans be
positioned stably.
GB 6

Safety instructions

CONTROLS

Igniting and adjusting

Each burner can be adjusted continuously between the high and low
positions.
1
1. 0-setting
2. Low setting
3. Burner indication
4. High setting
2
3
4
Controls
Press the control knob in and turn it anti-clockwise.
The burner ignites.
Hold the control knob pressed in for approximately 5 seconds to
switch the flame failure device on.
Attention! When the burner does not function after 15 seconds,
please wait one minute before re-trying to ignite the burner. Open a
door or a window in order to have sufficient ventilation.
Igniting and adjusting
GB 7