Installation Instructions; General - ETNA A026VWRVS Notice D'utilisation

FAULTS
FAULT CAUSE
The burner does not burn Burner parts incorrectly
evenly. installed.
Burner parts dirty or damp.
The burner goes out after Control knob not kept
igniting. pressed in long enough
(appliances with
flame failure device).
GB 12
Faults table
SOLUTION
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outflow holes are open.
Keep the control knob
pressed in for at least 5
seconds.

INSTALLATION INSTRUCTIONS

This appliance should only be connected up by a registered installer!
Please note
The type of gas and the country for which the appliance has been
designed are indicated on the application identification card.
This is a category 3 appliance.
Gas connection
• The gas connection must comply with national and local
regulations.
• We recommend that the hob be connected by means of a fixed
pipe. Connection using a specially designed safety hose is also
permitted.
• Behind an oven use must be made of a pipe made entirely out of
metal.
Please note
• A safety hose may not be bent and must not come into contact
with moving parts of kitchen units.
• In all cases the connection tap for the appliance must be
positioned such that it is easily accessible.
• Before using the appliance for the first time check the
connections using water and washing-up liquid to ensure
that there are no gas leaks.
Electrical connection
230 V - 50 Hz - 0.6 VA
• The electrical connection must comply with national and local
regulations.
• Wall socket and plug must be accessible at all times.
• If you want to make a fixed connection, ensure that a multi-pole
switch with a distance between contacts of 3 mm is installed in
the supply cable.
Please note
This appliance must be earthed.
GB 13

General