Basic Operation - Dimplex LA12MI Manuel D'utilisation

BASIC OPERATION

OFF / ON
TO TURN ON OR OFF THE UNIT
• When unit is ON, operation LED is lit and the actual
temperature for water outlet and outdoor ambient are
shown on the remote control display.
MODE
TO SELECT OPERATION MODE
HEAT HEAT +TANK
• HEAT MODE
- To turn ON or OFF the panel/fl oor heating operation.
- In this mode, the mono bloc unit will provide heating
capacity to the system.
• HEAT + TANK MODE
- In this mode, the mono bloc unit will provide heating
capacity to the sanitary tank and the system.
- This operation is not used when the sanitary water
tank is not installed.
• TANK MODE
- To turn ON or OFF the sanitary tank operation.
- In this mode, the mono bloc unit will provide heating
capacity to the sanitary tank.
QUIET
TO ENJOY QUIET ENVIRONMENT
• This operation reduces mono bloc unit noise. In this
condition, it may cause decrease in heating capacity.
TO ENABLE THE BACKUP
HEATER
HEATER
• The backup heater provides extra heating capacity
during cold outdoor temperature and only can operated
at heat mode operation when he was enabled by
pushing this button.
• The backup heater will automatically turn ON when the
setting conditions is fulfi lled.
• To disabled the Heater operation manually, press the
respective button again.
STATUS
CHECK
SYSTEM STATUS CHECK MODE
SEARCH
CHECK
1. Press for 5 seconds to enter STATUS mode.
2. Press or to check the Water Inlet
Temperature, Tank Temperature, Compressor Running
Frequency or Error History.
CANCEL
• Press to exit STATUS mode.
• Once STATUS mode is entered, "STATUS"
indicator is ON.
• STATUS mode cannot be activated when the
"SETTING" indicator is ON.
ADVANCE OPERATION
• It is strongly recommended to contact the nearest
• Using the remote control could set the temperature
SYSTEM SETTING MODE
TANK
1. Press
2. Press
3. After selecting the desired parameter, press
4. Press
5. Press
• Repeat steps 2 to 5 to set other parameters.
Operation
Mode
HEAT
HEAT
HEAT
HEAT
HEAT
HEATER
TANK
WATER TEMPERATURE THERMO SHIFT SETTING
1. Press
• Repeat steps 3 to 5 to set the desired shift temperature
Notes:
• Press
• The setting temperature will be stored in the system once
• "SETTING" mode cannot be activated when the
authorized dealer to change the water temperature range.
range for water outlet temperature and outdoor ambient
temperature.
Operation Mode
SETTING
SET
TIMER
HEAT
SELECT
TANK
ON
QUIET
HEATER
CANCEL
FORCE
OPERATION
Parameter *
SET
for 5 seconds to enter "SETTING" mode.
"SETTING" indicator is ON.
or to choose a parameter.
the parameter.
or to set the desired temperature.
SET
again to confi rm the setting.
Parameter * Description
Low outdoor ambient set temperature
(-15°C ~ 15°C).
High outdoor ambient set temperature
(-15°C ~ 15°C).
Water outlet set temperature at low
outdoor ambient temperature
(25°C ~ 55°C).
Water outlet set temperature at high
outdoor ambient temperature
(25°C ~ 55°C).
Water Temperature
Set temperature for turning OFF heating
OFF
operation (5°C ~ 35°C).
Outdoor ambient set temperature for
turning ON heater operation
ON
(-15°C ~ 20°C).
Sanitary tank set temperature
(40°C ~ 75°C).
SET
within 5 seconds.
(-5°C ~ 5°C).
CANCEL
or wait 30 seconds to exit "SETTING" mode.
confi rm.
"PUMPDW" and "STATUS" indicator is ON.
Temperature display
OUTDOOR
ACTUAL
HEATER
BOOSTER
C
SETTING
STATUS
PUMPDW
WATER OUTLET
SETTING indicator
SELECT
to enter
Outdoor Temperature
9