Scope Fof Delivery; Basic Device; Accessories Pack - Dimplex SI 50TUR Instructions D'installation Et D'utilisation

English
3

Scope fof Delivery

3.1 Basic device

The basic device consists of a ready-to-use heat pump for in-
door installation, complete with sheet metal casing, control
panel and integrated heat pump manager. The refrigerant cir-
cuit is hermetically sealed. It contains the Kyoto protocol ap-
proved refrigerant R410A with a GWP value of 2088. It is CFC-
free, does not deplete ozone and is non-flammable.
All components required for the operation of the heat pump are
located in the control box. An external temperature sensor in-
cluding fixing accessories, a dirt trap and a flow rate switch, is
supplied with the heat pump. The supply for the load current
and the control voltage must be installed by the customer.
The circulating pumps (brine and heating water side) included in
the scope of supply must be installed in accordance with the hy-
draulic diagrams (see cap. 3 on page XI) or the development
documents. The electrical connection of the circulating pumps
must be established in accordance with Cap. 7.6.3 on page 12.
Both the heat source system and the brine circuit manifold
must be provided on-site.
SI 70TUR
3
6
EN-4
1
5
4
452237.66.55 · FD 0007
SI 50TUR
3
6
2
1) Switch box
2) Evaporator
3) Liquefier
4) Compressor 1
5) Compressor 2
6) Expansion valve

3.2 Accessories pack

½" DN65 for the heat source side
 1x dirt trap 2
 1x hydraulic 4-way reversing valve DN 65 with actuator +
connection cable mounted
 4x threaded flange 2
 4x flange gasket 2
 16x screws M12 x 50
 16x washers 13 DIN 125
Annular spring 12.2 DIN 127
 16x nut M12
 4x double nipples 2
 1x assembly and usage instructions user
 1x assembly and usage instructions technician
 1x pipe assembly heating water flow
 1x pipe assembly heating water return
 1x external sensor
SI 50 - 70 TUR
1
5
4
"
½"
½"
www.glendimplex.de
2