Basic Device; Accessories; Brine Circuit Manifold; Transport - Dimplex SI 5BS Instructions D'installation Et D'utilisation

Pompe à chaleur eau glycolée-eau pour installation intérieure
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3

Basic Device

The basic device consists of a ready-to-use heat pump for indoor
installation, complete with plastic cover, control panel and inte-
grated controller. The refrigerating cycle contains the refrigerant
R407C. R407C refrigerant is CFC-free, non-ozone depleting and
non-combustible.
All components required for the operation of the heat pump are
located on the control panel. An external wall temperature sensor
including fixing accessories and a dirt trap are supplied with the
heat pump. The power feed for the load current and the control
current must be installed by the customer.
The supply lead of the brine circulating pump (to be provided by
the customer) must be connected to the control panel. If re-
quired, the supply lead of the brine pump is be equipped with a
motor protection device.
The customer must provide both the collector and the brine cir-
cuit manifold.
1)
Liquifier
2)
Compressor
3)
Control panel
4)
Evaporator
www.dimplex.de
All manuals and user guides at all-guides.com
4

Accessories

4.1 Brine circuit manifold

The brine circuit manifold merges the individual collector loops of
the heat source system into a single main pipe which is con-
nected to the heat pump. Integrated ball valves allow the individ-
ual brine circuits to be shut off for de-aeration purposes.
5

Transport

A lift truck is suited for transporting the unit on a level surface.
Carrying straps may be used if the heat pump needs to be trans-
ported on an uneven surface or carried up or down stairs. These
straps can be passed directly underneath the wooden pallet.
ATTENTION!
The heat pump is not secured to the wooden pallet.
ATTENTION!
The heat pump must not be tilted more than 45° (in any direction).
Use the holes provided in the sides of the frame to lift the unit
without the pallet. This requires the plastic device cover to be re-
moved. Any commercially available length of pipe can be used
as a carrying aid.
ATTENTION!
Do not lift the device by its plastic cover!
5
E-3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Si 7bsSi 9bsSi 11bsSi 14bs

Table des Matières