Technical Specifications - BEA LZR-MICROSCAN Mode D'emploi

TECHNICAL SPECIFICATIONS

Technology:
Detection mode:
Detection width:
Mounting Height:
Remission factor:
Angular resolution:
Testbody:
Emission characteristics:
IR laser:
Supply Voltage:
Power Consumption:
Response time:
Output:
Rating:
Input:
Rating:
Test Input *:
Temperature Range:
Degree of Protection:
Humidity:
Vibrations:
Material:
Norm Conformity:
Mounting angle
(rotational):
Tilt angle:
Pollution on front
screens:
Specifications are subject to change without prior notice.
All values measured in specific conditions.
For version compatibiltiy serial number information, please see Application Note 76.0017 or
contact BEA for technical support.
ANSI / AAADM Compliance
Upon completion of the installation or service work, at a minimum, perform a daily safety check in accordance with the minimum
inspection guidelines provided by AAADM. Provide each equipment owner with an owner's manual that includes a daily safety
checklist and contains, at a minimum, the information recommended by AAADM. Offer an information session with the equipment
owner explaining how to perform daily inspections and point out the location of power/operation switches to disable the equipment if
a compliance issue is noted. The equipment should be inspected annually in accordance with the minimum inspection guidelines. A
safety check that includes, at a minimum, the items listed on the safety information label must be performed during each service call.
If you are not an AAADM certifi ed inspector, BEA strongly recommends you have an AAADM certifi ed inspector perform an AAADM
inspection and place a valid inspection sticker below the safety information label prior to putting the equipment into operation.
Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462 | General Tech Questions: Tech_Services@beainc.com | Tech Docs: www.beasensors.com
Page 12 of 12 Page 12 of 12
laser, time-of-flight measurement
presence
20"-48"
75"-98"
> 2%
2.56 °
28" (H) x 12" (W) x 8" (D) according to UL325
wavelength 905 nm; max. output pulse power 35 W (CLASS 1)
12-30 V DC (15 W Class II)
< 15 W
typ. 40 ms; max. 80 ms
4 electro-mechanic relays (galvanic isolated - polarity free)
All outputs Class 2 supply, 12-24 VAC, 12-30 VDC, Max 15 W
2 optocouplers (galvanic isolated - polarity free)
12-24 VAC, 50/60 HZ, 12-30 VDC, Max 15 W
8-15 VDC
-13 °F to +121 °F (-25 °C to +55 °C)
Hub - IP20/NEMA 1
0-95 % non-condensing
< 2 G
PC/ASA
EN 60825-1-Eye-safety class 1 IR laser (905 nm), UL325, UL6730
35° fixed
0° to 5° (for angles less than 5° contact Tech Support)
max. 30 %; homogenous
* SEE APPLICATION NOTES OR CONTACT BEA FOR TECHNICAL SUPPORT
(measured from leading edge to sensor LED)
(measured from finished floor to sensor LED)
Sensor - IP53/NEMA 3
75.5753.10 LZR-MICROSCAN 20170310 75.5753.10 LZR-MICROSCAN 20170310