BEA LZR-MICROSCAN Mode D'emploi page 6

INSTALLATION (cont.)
Peripherals
Logic modules must be activated by Hub via Door Control Harness activation wires.
Home Switch
1
1
Install Home Switch at desired
location.
NOTES:
1: Any dry contact home switch or auxiliary switch may be used and
must be closed when door is closed.
2: For simultaneous pairs or dual egress doors, two (2) Home
Switches must be wired in series with orange wires of System
Harness plugged into
On / Off / Hold Open Switch
1
Determine mounting location,
apply mounting template, drill
holes.
Page 6 of 12 Page 6 of 12
All activation devices must be wired directly to Hub.
Switch must "break" as soon as door begins to open.
2a
For single doors, wire nut
white Home Switch wires
to orange wires of System
Harness plugged into hub.
hub.
2
Route On / Off / Hold Open
Switch harness and plug into
hub port labeled On / Off /
Hold Open.
IMPORTANT:
2b
For pairs of doors, wire nut
white Home Switch wires
in series to orange wires of
System Harness plugged into
hub .
2
If using an existing on / off / hold
open switch, plug On / Off / Hold
Open Switch Jumper into hub
port labeled On / Off / Hold
Open and wire nut red and black
wires together, or if desired, splice
existing switch into Jumper.
FUNCTION JUMPER WIRES
on red jumped to black
hold open black jumped to white
off
75.5753.10 LZR-MICROSCAN 20170310 75.5753.10 LZR-MICROSCAN 20170310
none