BEA LZR-MICROSCAN Mode D'emploi page 7

INSTALLATION (cont.)
Eagle (Optional)
1
Install Eagle(s). For complete
installation instructions refer
to BEA User's Guide 75.0058.
Push Plates (Optional)
Multiple push plates can be paralleled to grey wires of System Harness.
1
Install push plate(s). For com-
plete installation instructions
refer to the appropriate BEA
User's Guide .
1
Door Control Harness
If door system utilizes independent door controls, repeat steps 1-2 for the second
control. Do not use door control sync cable.
For dual egress doors with independent stall, two (2) Door Control Harnesses must be
used.
1
Plug Door Control Harness
into hub port labeled Door
Control A.
75.5753.10 LZR-MICROSCAN 20170310 75.5753.10 LZR-MICROSCAN 20170310
2
Plug Eagle Harness(es) into
hub port labeled Motion 1
and, if applicable, Motion 2.
2
COM
NO
Wire nut push plate wires or
wireless receiver (COM and
NO) to grey wires of System
Harness plugged into hub.
2
Wire Door Control Harness to
door control.
Page 7 of 12 Page 7 of 12