Removing The Protective Cover From The Handlebars; Mounting The Pedals; Mounting The Front Luggage Rack - Schindelhauer Bikes Viktor Manuel D'utilisation D'origine

15 Removing the protective cover from the
handlebars
WARNING
!
EN
Risk of accident and injury!
Never cycle with the protective cover on the handlebars. The handle-
bars can twist while cycling.
» Remove the protective cover of the handlebars before the first ride.
Remove any protective cover from the handlebars before riding.
1. Unscrew the screws on the stem cap and remove the stem cap (fig. 6).
2. Remove the handlebars carefully towards the front.
3. Cut and remove the protective cover from the handlebars.
4. Apply some assembly paste to the clamping areas of the stem body
and cap (fig. 7).
5. Insert the handlebars in the middle of the stem, place the cover cap and
tighten the screws.
6. Tighten the four screws of the stem cap alternately so that there is an
even gap between stem cap and stem body (fig. 8).
7. Tighten the screws (5-6 Nm).
The brake grips are premounted and screwed in for transport
reasons. Adjust the handlebar and brake lever inclination
as desired ⇨ section "Basic settings and ergonomic
adjustments" page 133 .
128
6
7
8
16

Mounting the pedals

Please keep in mind:
» The left pedal has a left-hand thread. It can be recognised
by a groove in the pedal axle flange (arrow fig. 9).
» You need a 6 mm Allen key to mount the pedals.
1. Slide the washers 1 onto the pedal threads (fig. 9).
2. Wet the pedal threads with the provided assembly paste.
3. Screw the pedals to the crank arms and tighten them (35 Nm) (fig. 10).
9
1 1
10
17

Mounting the front luggage rack

NOTE
Risk of damage!
The luggage rack holder was developed especially for the Schindel-
hauer aluminium front luggage rack. Mounting another luggage rack or
other components can damage the bike.
» Do not mount another luggage rack or other components on the
luggage rack.
» Do not fit the mounting bolts without the front carrier, as this may
block the steering.
Gustav / Greta
Depending on the model, your bike already has an aluminium front luggage
rack or it can be retrofitted with one.
1. Unscrew the dummy plugs 1 on the left and right side of the head
tube.
2. Now hold the front carrier with its 4 connection points congruently over
the side holes in the head tube (fig. 11).
3. Make sure that the cable ropes run between the left receptacle of the
luggage rack (in the direction of travel) and the head tube.
4. Insert the supplied washers between the front carrier and the two lower
mounting holes. Screw both screws about halfway into the threaded
hole so that the luggage carrier is fixed in place (fig. 12).
5. Now insert the other two washers between the luggage carrier and the
upper mounting holes of the head tube and screw in the bolts.
6. Then tighten all 4 screws evenly (15 Nm) (fig. 13).
EN
129