Table des Matières
Publicité
e
BASIC STITCHES
Straight Stitch
Machine settings
Pattern:
q
Presser foot:
w
Thread tension:
e
To sew
Raise the presser foot and position the fabric next to a
seam guide line on the needle plate. Lower the needle
into the fabric where you wish to start.
Pull the needle and bobbin threads to the back.
Lower the presser foot.
Depress the foot control to start sewing. Gently guide
the fabric along the seam guide line.
Changing sewing direction:
Stop the machine a few stitches before the end of a
seam. Press the up/down needle button a few times
until the needle falls on the end of the seam.
Up/Down needle button
q
Raise the presser foot.
Pivot the fabric around the needle to change the
sewing direction as desired.
q
Lower the presser foot and start sewing in a new
direction.
Securing a seam
For fastening the beginning of a seam, press the
reverse button and sew several reverse stitches.
Release the reverse button to sew forward.
Reverse button
w
w
For fastening the ends of a seam, press the reverse
button at the end of the seam.
Sew a few stitches in reverse to fasten the seam.
Raise the presser foot and pull the fabric to the back
to remove it.
To cut the threads, pull the fabric to draw the threads
up to the thread cutter as shown.
The threads are cut a proper length to start the next
seam.
Thread cutter
e
When pattern #03 (lock-a-matic stitch)
The machine will sew reverse stitches at the beginning
of a seam automatically, and at the end of the seam
by pressing the reverse button once.
28
#01
Zigzag foot A
2-6
is selected:
Publicité
Table des Matières
