Built-In Needle Threader; Drawing Up The Bobbin Thread - Janome S-7330 Manuel D'instructions

z
q
x
cv
z
x
w
c
q
w
w
e
w
q
e

Built-in Needle Threader

1 Raise the needle to its highest position by turning
the hand wheel toward you.
Turn the power switch off.
Lower the presser foot.
Depress the needle threader knob as far as it will go.
The hook comes out through the needle eye from
behind.
Needle threader knob
q
Hook
w
2 Draw the thread down around the threader guide
and under the hook.
Threader guide
e
3 Release the threader knob slowly while holding the
thread end with your hand. A loop of the thread is
pulled up through the needle eye.
4 Remove the loop from the threader and pull out the
thread end from the needle eye.
NOTES:
The automatic threader works well with the threads
#50-90 and needles #11-16.

Drawing Up the Bobbin Thread

1 Raise the Presser Foot Lifter.
Turn the power switch on.
2 Hold the needle thread with your finger and press
the Up/Down needle button twice to pick up the
bobbin thread.
Draw up the needle thread to bring up a loop of the
bobbin thread.
Needle thread
q
Bobbin thread
w
Up/Down needle button
e
3 Slide 10 cm (4") of both threads to the back under
the presser foot.
26