Table des Matières
Publicité
q
q
w
w
r
z
q
x
w
q
w
q
e
r
e
w
Dropping the Feed Dog
The feed dog can be lowered with the drop-feed lever
for sewing on buttons etc.
Shift the drop-feed lever to the right to lower the feed
dog.
Shift the lever to the left to raise the feed dog, it will
return to the up position when the machine is started.
Down position
q
Up position
w
Feed dog
e
Hand wheel
r
NOTE:
The feed dog should be in the up position for regular
sewing. Turn the handwheel toward you to check if
the feed dog comes up after setting the lever in the up
position.
Changing the Presser Foot
CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
To snap off:
Raise the needle and presser foot.
Press the lever on the back of the foot holder and the
foot will drop.
Lever
q
To snap on:
Place the presser foot so the pin on the foot lies just
under the groove of the foot holder.
Lower the foot holder to lock the foot in place.
Groove
w
Pin
e
Each foot is marked with a letter for identification.
Identification Letter
r
Detaching and Attaching the Foot Holder
WARNING:
Turn OFF the power switch before detaching or
attaching the foot holder.
To detach:
Raise the presser bar and turn the setscrew
counterclockwise to remove the foot holder.
Setscrew
q
Foot holder
w
To attach:
Align the hole in the foot holder with the threaded hole
in the presser bar and insert the setscrew through the
hole.
Tighten the setscrew by turning it clockwise.
14
Publicité
Table des Matières
