Threading The Machine - Janome S-7330 Manuel D'instructions

w
y
i
z
w
e
x c
r
t
v
bn
q
t
u
y
u
i

Threading the Machine

1 Draw the thread from the spool. Hold the upper
thread at the spool with your finger.
Hold the thread
q
2 Slip the thread under the thread guide from the
right and down along the right channel.
Be sure that the thread passes between the
tension disks.
Thread guide
w
Right channel
e
Tension disks
r
3 Then draw the thread around the bottom of the
thread guide plate.
Thread guide plate
t
4 Firmly draw the thread up along the left channel
to the take-up lever and down into its eye from the
right to the left.
Thread take-up lever
y
5 Then down through the lower thread guide.
Lower thread guide
u
6 Slide the thread behind the needle bar thread guide
on the left.
Needle bar thread guide
i
Thread the needle from front to back by hand or
use the built-in needle threader (see page 26).
24
Raise the presser foot.
Press the Up/Down needle
button to raise the thread
take-up lever to its highest
position.