Install The Decorative Door Panels (Nonmetal Door Models) - Norcold N109 Serie Manuel D'installation

6. Install the upper mounting flange and the lower mounting flange in the original
positions (See Art01683):
Make sure that both foam pads [212] remain in
!
WARNING
position on each mounting flange to complete the
combustion seal. If the seal is not complete, exhaust
fumes can be present in the living area of the vehicle.
The breathing of exhaust fumes can cause dizziness,
nausea, or in extreme cases, death.
- Make sure that both foam pads [212] remain in position on each mounting
flange to complete the combustion seal.
- Attach the upper mounting flange [210] and the lower mounting flange [211]
with four screws [41].
The lower mounting flange has more bends than the upper
NOTICE
mounting flange.
- Securely tighten the screws.
7. Reinstall the doors (See Art01684):
- Make sure each hinge bushing [74] is in the correct position.
- Put each hinge bushing into the bottom side of each door hinge.
- Put each door in the position on the refrigerator.
To prevent damage to the threads of the hinge pins, turn
NOTICE
the hinge pins by hand until tight and then tighten with a
screwdriver.
Apply Loctite removable thread locker (blue) to the
!
CAUTION
threads of the hinge screws before assembly to prevent
loosening during use. Do not allow Loctite to contact any of the plastic surfaces of the refrigerator
because it can damage those surfaces.
- Align the hinges and put the hinge pins [71] into each door hinge.
- Tighten the hinge pins.
- Put the storage bins in the doors.
8. To install the upper and lower trim pieces refer to the "Install the Refrigerator" section of this manual.
Install Decorative Door Panels (non-metal door models)
The doors are made to accept decorative panels. The decorative panels
NOTICE
must be 3/16 inch or less in thickness. Install the decorative door panels in
the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 14 17/32 inches high.
- Make a lower door panel that is 21 19/32 inches wide x 38 5/8 inches high.
- Pull the panel retainer [37] off each door (See Art00965).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.
250b
41
65a
251b
Art01685
38
37
41
250a
251a
65b
250a
250b
39
Art00965
Installation Manual 15