Install The Decorative Door Panels - Norcold NX64 Manuel D'installation

- Make sure that the baffle is against the wall of the vehicle at the top of the upper exhaust vent and 1/4 inch or less
from the top of the opening for the upper exhaust vent [15].
- Make sure the baffle is the full width of the inside of the enclosure.
- When using an upper side-wall exhaust vent:
- If the depth of the enclosure is 24 inches or more and is less than 26 inches [27], install a bent aluminum or galvanized steel
sheet baffle [26] to the rear of the enclosure (See Art01592).
- Make sure that the bend of the baffle is the full width of the inside of the enclosure.
- Make sure that the bend of the baffle is flush with the bottom edge of the upper intake vent door frame.
- Make sure that the top edge of the baffle is 1/4 inch [213] below the bottom of the condenser and that there is 1/4 inch or
less clearance [15] between the rear of the condenser and the baffle.
- If the depth of the enclosure is more than 26 inches [27], install a wood or an aluminum or galvanized steel sheet solid box
baffle [21] between the lower intake vent and the upper exhaust vent (See Art01593).
- Make sure that the solid box baffle is the full width of the inside of the enclosure.
- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4
1/4 inches to 4 3/4 inches above the top of the lower intake vent opening REF) [18] .
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box baffle is even with the bottom edge of the upper exhaust vent [24].
- Make sure that the vertical top edge of the baffle is between 1/4 inch [213] below the condenser and 1 1/2 inches above
the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.
Install Decorative Door Panels
The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
NOTICE
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 15
11/16 inches high.
- Make a lower door panel that is:
- 21 19/32 inches wide and
- 32 25/32 inches high (for NX6 models) or
- 39 25/32 inches high (for NX8 models).
- Pull the panel retainer [37] off each door (See Art02385).
- Push the decorative door panel [38] into the slots of the door
[39].
- Push each panel retainer into the slot on the edge of the door.
Installation Manual 10
37
39
38
Art02385