Install An Air Deflector (Optional); Install Decorative Door Panels (Non-Metal Door Models) - Norcold 121XAC Serie Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Install an Air Delflector (optional)
If the floor plan has the refrigerator on the rear wall of
the vehicle, obey all of the vent installation as written in
the "Install the Lower and Upper Vents" section of this
manual. Install the roof exhaust vent so that:
- The sloped end of the roof exhaust vent is toward
either side of the vehicle.
- The roof exhaust vent is perpendicular to the air
flow over the vehicle.
Install an air deflector on the roof of the vehicle between
the roof exhaust vent and the front of the vehicle (See
Art01271).
- Make sure that the air deflector [175] is between the
roof exhaust vent [24] and the front of the vehicle
[179].
- Make sure that the air deflector is at least 3 1/2
inches high [176].
- Make sure that the overall width [177] of the air deflector is 32 7/8
- Make sure that the distance between the air deflector and the roof exhaust vent is between 2 and 3 inches [178].

Install Decorative Door Panels (non-metal door models)

NOTE: The doors are made to accept decorative panels. The decorative panels must
be 3/16 inch or less in thickness. Install the decorative door panels in the
refrigerator doors before installing the refrigerator in the vehicle.
1. Make two upper door panels that are 16 13/64 inches wide x 18 3/8 inches high:
- Raised panels must be centered on each door and no larger than 15 11/32 inchs
wide x 17 17/32 inches high.
2. Make two lower door panels that are 16 13/64 inches wide x 41 13/64 inches high:
- Raised panels must be centered on each door and no larger than 15 11/32 inchs
wide x 40 11/32 inches high.
3. Install the decorative door panels:
- Pull the panel retainer [37] off of each door [39] (See Art01794).
- Push a decorative door panel [38] into the slots of each door.
- Make sure that each panel retainer is correctly positioned and push the curved
snap [125] of the panel retainer [37] inside of the curved snap [126] of the
door (See Art01648).
Installation Manual 14
175
176
177
179
126
37
24
178
Art01767
37
38
39
Art01797
125
Art01794

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

121 serie121x serie

Table des Matières