Install The Refrigerator; Installation Options; Install The Decorative Door Panel - Norcold N300 Serie Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- If there is more than 1 inch of clearance between the rear of the refrigerator and the enclosure, add two baffles [17] to the rear
of the enclosure (See Art01630 and Art01632):
- Make sure the distance [290] from the bottom of the enclosure to the top of the lower baffle is between 10 and 10 1/2
inches.
- Make sure the lower baffle is between 1/4 and 1/2 inch [191] from the coils of the refrigerator.
- Put the upper baffle at the lower edge of the condenser [11] of the refrigerator.
- Make sure the upper baffle is between zero (0) and 1/4 inch [15] below and zero (0) and 1/4 inch away from the
condenser of the refrigerator.
- Make sure both baffles are the full width of the inside of the enclosure.

Install the Refrigerator

Put the refrigerator in position (see Art01253):
Make sure the combustion seal [28] is not broken, is completely
!
WARNING
around the refrigerator mounting flanges [156], and is between
the mounting flanges and the wall of the enclosure. If the
combustion seal is not complete, exhaust fumes can be present
in the living area of the vehicle. The breathing of exhaust fumes
can cause dizziness, nausea, or in extreme cases, death.
- Remove the door from the refrigerator (See "Reverse the door swing" section).
- Put screws through the holes of the refrigerator mounting flanges and into the
enclosure wall.
To avoid bending the breaker, make sure that the screws are
NOTICE
perpendicular to the breaker and do not overtighten the screws.
- Attach the door to the refrigerator.
- Put a screw through the holes [121] in the braces at the lower rear corners of the
refrigerator and into the floor.

Installation Options

Install the decorative door panel:

NOTICE
The decorative panels must be 3/16 inch or less in thickness.
- Make a decorative door panel [38] that is 25 15/16 inches high x 20 1/8 inches
wide (See Art00977).
- Push the decorative door panel into the slots [157] of the door end caps [158].
- Push each panel retainer [37] into the slot on the edge of the door.
121
Art01253
157
37
38
Installation Manual 7
28
156
158
Art00977

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

N300x

Table des Matières