Routine Maintenance; Maintenance Of Cartridge Filters; Maintenance Of Thermal Cover - Jacuzzi DELFI Utilisation Et Entretien

ROUTINE MAINTENANCE

Keep the spa covered at all times when not in use. In this way,
along with keeping the water from getting dirty, you will also
avoid heat loss and evaporation.
Periodically clean the hydromassage and suction nozzles.
CAUTION
After cleaning, immediately put the grilles of the aspira-
m
tion nozzles back in place. These safety devices must co-
ver the suction intake in order to reduce the risk of hair
or other body parts getting caught. The intakes must be
cleaned with the bath empty.
Remember to refit all the parts before re-filling the spa.
The suction intake grilles must be checked at least once
a week.
Regularly clean the headrests using a cloth, soap and water.
You are advised to use protective products to increase water re-
sistance and maintain their shiny appearance.

Maintenance of cartridge filters

The filters must be periodically cleaned according to the amount
of use of the spa and replaced when necessary
The cartridges are available from Jacuzzi® authorised dealers
and Service Centres.
Check the skimmer at least once a week to remove any sedi-
ment such as leaves, hair, etc.
With normal use of the spa, it is advisable to clean the filters
at least once a week. If necessary, the filters should be cleaned,
because clogged filters cannot keep the water clean. They also
compromise proper operation of the system.
To clean the filters, remove the skimmer cover (C), unscrew
the filter baskets and take them out.
2
4
Separate the filter folds and clean with a jet of pressurised water.
If the filter is clogged, it is advisable to use specific products for
the removal of encrustation and grease, available from authori-
zed Jacuzzi® dealers and service centres.
Refit, repeating the operations in reverse order.
CAUTION
After cleaning the filters, do not re-start the spa until
m
you have re-assembled all components.

Maintenance of thermal cover

Fabric
Remove the cover from the support frame and lay it on a
straight surface.
Dampen the fabric with clean water. For a plastic cover, you
can proceed directly with cleaning.
Evenly spread a diluted solution of neutral soap on the sur-
face.
Let the solution stand for 2-3 minutes, depending on the
degree of dirtiness.
29
1
3