Xylem SI Analytics TitroLine 7500 KF Mode D'emploi page 101

101
Fig. 35
When the final criteria are met, then there is an audible signal and Conditioning ready is shown on the display:
Fig. 36
The conditioning remains active until the actual titration is started by pressing <F1/START>. You are prompted
immediately to add the sample:
Fig. 37
After the sample or the standard is added, you must press <F1/START> again. Depending on the method
settings, you will be prompted for the sample identification (Fig. 38) and the weighed-in quantity (Fig. 39). You
can use an external PC keyboard for entering a 20-digit alphanumeric sample ID.