Installation And Commissioning; Safety Instructions; Montage - Burkert PTB 01 ATEX 2194 X Mode D'emploi

7 INSTALLATION AND
COMMISSIONING

7.1 Safety Instructions

DANGER!
Danger of explosion!
• The device is a sealed system. The unit must not be dismantled!
The following safety regulations must be observed::
• The surface of the device may develop an electrostatic charge.
In areas with an explosion hazard, the surface of the units may only
be cleaned with a damp cloth!
• Only permanently laid cables and wiring may be inserted.
• The operator must provide suitable stress relief.
High voltage!
Acute risk of injury from hazardous structure-borne voltage!
Risk of damage to the device due to short circuit!
• Work on the electrical system may only be carried out by qualifi ed
electricians!
• Before starting work, switch off the power supply and secure to
prevent it being switched on again!
• The connecting cables to the electromagnets must be secure,
and be laid so that they are adequately protected from mechanical
damage.
• Observe the applicable accident prevention and safety regulations
for electrical devices!
01 ATEX 2194 X
WARNING!
Pressurised system!
Interventions in the pneumatic system represent an acute risk of
injury.
• Work on the pneumatic system may only be carried out by qualifi ed
and instructed personnel using appropriate tools.
• First switch off pressure before disconnecting lines and valves!
• Observe the fl ow direction during installation!
• Observe the applicable accident prevention and safety regulations
for pneumatic systems!

7.2 Montage

NOTES:
Installation in any position.
Preferably with solenoid system mounted at the top.
Activity
→
Clean the pipe runs
→
Installation in any position
→
Connect a dirt-trap (strainer)
upstream
→
Seal
- 15 -
Notes
-
Preferred direction with drive
mounted at the top
Note the direction of fl ow!
PTFE
english