Starting Additional Output - Sentiotec Pro C3 Instructions D'installation Et D'utilisation

Instructions for use for the user
The evaporator (humidity function B) can only be started when the sauna
heater (temperature function A) is switched on. The maximum humid-
ity level which can be set depends on the temperature of the sauna.
The higher the sauna temperature, the lower the maximum humidity
level which can be set.

10.5. Starting additional output

Infrared lamps, or infrared heat plates, for example, can be connected to the
additional output on the sauna control unit.
WARnInG!
Risk of fi re
Flammable objects that are placed on or in front of the infrared lamp
could ignite and cause fi res.
● NEVER place fl ammable objects on or in front of the infrared lamp.
● Make sure that NO fl ammable objects have been placed on or in front
of the infrared lamp before you switch it on.
When the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set to a scale of 0 to 7. At 0, the additional device
is switched off. 7 corresponds to full power.
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
2. Use the intensity selector 3 to set the preferred power
of the additional device.
3. Press the intensity selector 3.
► The additional device switches on.
► The intensity selector 3 lights up.
WORLD OF WELLNESS
p. 37/52
En