Air Filter; Fuel Filter - Shindaiwa DH212 Mode D'emploi

a
Ir fIlter
level 1.
Tools required: 25 or 50 mm (1 or 2 in.) cleaning brush
1. Close choke (Cold Start Position [
the carburetor throat when the air filter is removed. Brush accumulated
dirt from air cleaner area.
2. Remove air filter cover. Brush dirt from inside cover.
3. Remove air filter and lightly brush debris from filter. Replace filter if
it is damaged, fuel soaked, very dirty, or the rubber sealing edges are
deformed.
4. If filter can be reused, be certain it:
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
5. Install air filter cover.
NOTe
Carburetor adjustment may be needed after air filter cleaning/replacement.
f
uel fIlter
level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved
fuel container
DANGER
Fuel is VeRy flammable. Use extreme care when mixing, storing
or handling.
1. Use a clean rag to remove loose dirt from around fuel cap and empty
fuel tank.
2. Use the "fuel line hook" to pull the fuel line and filter from the tank.
3. Remove the filter from the line and install the new filter.
All manuals and user guides at all-guides.com
). This prevents dirt from entering
17