Restoring The Original Configuration - SOMFY Heating Slim Receiver io 2kW Notice

EN
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for approximately 10 seconds
(for at least 5 seconds but no longer than 15 seconds).
3) Cut the power supply for 2 seconds.
4) Switch the mains power supply back on.
The heating lamp turns on then turns off.
5) Briefly press the PROG button on the new io control point.
The heating lamp comes on then goes out.
The new control point is programmed in the io 2kW
Heating Slim Receiver.

2.6.3. Restoring the original configuration

Attention
• Only switch the power off twice to the io 2kW Heating Slim Receiver to be reset!
• This reset deletes all programmed control points.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for approximately 10 seconds
(for at least 5 seconds but no longer than 15 seconds).
3) Cut the power supply for 2 seconds.
4) Switch the mains power supply back on.
The heating lamp turns on then turns off.
5) Press the PROG button on the io local control point until the
heating lamp turns on then turns off twice.
The receiver is reset to its original configuration.
6) Repeat the commissioning procedures (see 2.3.).
22 Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Heating Slim Receiver io 2kW
OFF
2 s
5 s
ON
15 s
OFF
2 s
ON
OFF
2 s
5 s
ON
15 s
OFF
2 s
ON