SOMFY Heating Slim Receiver io 2kW Notice page 21

Heating Slim Receiver io 2kW
Precaution
• Always make a loop in the power supply cable
to prevent water from entering the receiver.
• Check that the power of the heating lamp
connected to the io 2kW Heating Slim Receiver
does not exceed 2,000 W.
• Never connect several io 2kW
Heating Slim Receivers to a single heating lamp.
• Ensure that the electrical network is protected by a 16 A circuit breaker.
Attention
• The io 2kW Heating Slim Receiver must be installed in a location protected from the rain and
inclement weather and out of sight and reach of children.
• Install the 2kW Heating Slim Receiver io in a waterproof connection box (not supplied) when
performing the connections.
• If the receiver is used outdoors and if the power supply cable is of the H05-VVF type, run the
cable in a UV-resistant duct, e.g. trunking.
• Do not install the io 2kW Heating Slim Receiver under the heating lamp.
• Secure cables to prevent any contact with moving parts.
• Leave the receiver power supply cable accessible: it must be possible to replace it easily.
• To ensure that the radio signal is transmitted correctly, it is necessary to pull at least 30 cm
of the io 2kW Heating Slim Receiver power supply cable out.
1) Cut off the mains power supply.
2) Disconnect the heating lamp cable from the power supply cable.
3) Connect the io 2kW Heating Slim Receiver to the heating lamp
cable (A) and to the power supply cable (B) using suitable connectors.
mm
Ø ≥ 0.75
A
Blue Output
Brown Output
Green/ Earth
yellow
4) Fasten the io 2kW Heating Slim Receiver (for example using clamps).
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2
B
B
Blue Neutral input (N)
Brown Live input (L)
Green/ Earth
yellow
OFF
A
EN
19