Installation Steps - Faber FEG4916F Manuel D'instructions

Installation Steps

1 . Prior to starting the installation, make sure you read and understand all WARNING information in this manual .
Do not start the installation if you are unclear about any of the installation-related subjects .
2 . Determine the following:
• The vent system configuration to be used based on the fireplace location .
• Clearance requirements from combustible and non-combustible materials .
• Gas supply piping .
• Electrical wiring requirements .
• Framing and finishing details .
3 . Unpack the fireplace box, following instructions for fireplace unpacking .
4 . Put the fireplace in the desired location . Verify clearance to non-combustible and combustible materials . Follow
the clearance instructions in this manual .
5 . Attach the brackets of the unit to the wall framing
6 . Connect the vent system to the fireplace .
7 . Connect the gas line to the fireplace and verify gas inlet and outlet pressure .
8 . Confirm if adjustments for high altitude are needed (installation at above 4500 ft from sea level) .
9 . Install receiver batteries or if using mains power, ensure electrical outlet is within 2 .5 m and plug AC/DC
adaptor to receiver and to wall receptacle .
10 . Insert and place Fireplace media . Use media arrangement guide from the manual .
11 . Verification of: • Ignition and pilot system .
• Burning and flame .
• Remote control Setup
12 . Complete framing and wall cover .
13 . Remove blue protective film from glass and clean glass .
14 . Re-install the glass, and unpack and install the safety barrier .
15 . Ensure the homeowner is familiar with operation of the fireplace and remote control, and can locate the ignition
instructions and rating label .
16 . Ensure the homeowner has paperwork showing the details of the fireplace (model, serial number, installation
date) and the details of the installer .
17 . Ensure the homeowner is aware of regular maintenance schedules and potential problems that will require
service .
Read all the instructions before starting the installation . Follow these instructions carefully
during the installation to ensure maximum safety and benefit . Follow the steps above to
ensure proper installation of the gas appliance .
WARNING! Risk of fire or explosion! Damaged parts could impair safe operation .
DO NOT install damaged, incomplete or substitute components .
21
WARNING
!
FaberFires.com