Frame Power Supply (Optional) - Winkhaus blueMatic EAV Instructions D'installation

blueMatic EAV
EN
3
Plug with cable reserve
Frame part positioning depen-
ding on rebate geometry.
Recommended: Either flush
with the frame edge or recessed
approx. 3 mm.
Figure 3.1.1-6: Sectional view in 4 mm wood (incl. spacer plate)
3.2

Frame power supply (optional)

General instructions
• We recommend: Install the frame power supply in the upper third of the
door on the hinge side.
• Installation direction: Input side (230 V) always downward.
• Approx. 10 cm of reserve cable is required for installation for electrical com-
ponents with cable connections.
• The reserve cable is in the cut-out behind the frame power supply. The ∅ 13
mm drill hole for the 230 V cable passage is horizontal through the entire
frame, deburr the drill hole on both ends and use the cable passage to guide
the cable through the metal profile!
The frame power supply is positioned over spacers for plastic profiles (see p.
22).
• Screws for fastening the frame power supply in the door frame, max. 4 x 20
mm!
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
STK/RNT 34 5051251
by frame or to
milled groove