SOUNDMASTER NR50 Mode D'emploi page 24

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
Operation
-
Remove the stylus protector
-
Be sure that the tone arm is being detached from
the tone arm rest before operating and re-
secured again afterwards
IMPORTANT before use:
The device has a transport protection!
Rotate this with a coin or a screwdriver (Clockwise to the right)
completely!
1. Select the "Phono" mode by pressing the function button.
2. Set the speed selector to the position corresponding to the record.
3. Place the record on the turntable (use the spindle adaptor if required).
4. Set the tone arm lever to the up position.
5. Lift the tone arm from the rest and slowly move it to the record side. The turntable will start
to rotate. Position the tone arm over the desired position of the record.
6. Pull down the tone arm lever. The tone arm will come slowly on the record and start the
playback.
7. At the end of record, the tone arm will return to the rest position automatically.
8. To stop manuallythe playback, lift the tone arm from the record and return it to the rest.
Playback Play/Pause
Set the tone arm lever to the up position, the tone arm will lift up and the playback will be
interrupted. Set the tone arm lever to the down position, the tone arm will be lowered and
the playback will be continued.
Remark:
-
Due to the transport, it is possible that the automatic turntable deactivation was
influenced during the first start-up. This means that the tone arm automatically moves
back to the tone arm holder during the first operation. This is not a mistake!
-
Due to the different length of the record, it is possible that the tone arm does not
automatically return to the tone arm mount. Please adjust your turntable as described
below.
Important:
To ensure that the turntable can play all the different records, there is an opening on the back of
the unit labeled "NO OPEN", with the screw to adjust the turntable.
If the record turns off too soon, take a screwdriver and turn the screw in the opening clockwise
(to the right) about 45 °. Repeat this step until the record turns off at the correct point. If the
record turns off too late, take a screwdriver and turn the screw counterclockwise (to the left)
about 45 °
PHONO
9
NR50 / English Instruction Manual
Cartridge
Cartridge protector

Publicité

Table des Matières
loading

Table des Matières