Settings: Pump Address; Settings: Set Time - Pentair STA-RITE INTELLIFLO VSD Serie Manuel D'installation Et D'utilisation

14
IntelliFlo VSD Pump Menus
®
The IntelliFlo

Settings: Pump Address

The "Pump Address" setting is used when the IntelliFlo
to an IntelliPool or IntelliComm
or IntelliComm
Note: IntelliFlo
To access the Settings menu:
1. Be sure the green power LED is on and the pump is stopped.
2. Press the Menu button. "Settings" is displayed.
3. Press the Select button. "Pump Address" is displayed. The Factory default setting is address
"1."
4. To change the pump address, press the Select button. The first digit "1" selected.
5. Press Up or Down arrow button to change the address number from 1-16.
6. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
7. Press the Escape button to exit.

Settings: Set Time

Use "Set Time" to set the IntelliFlo
start and stop times, functions, and programmed cycles. The system clock can store the correct time for
up to 96 hours after power is shut off. The IntelliFlo
a reset is needed.
To access the Set Time menu:
1. Check that the green power LED is on.
2. Press the Menu button. "Settings" is displayed.
3. Press the Select button. "Pump Address" is displayed.
4. Use the Up or Down arrow button to scroll to "Set Time"
5. Press the Select button. The cursor will appear in the Minutes column.
6. Press Up or Down arrow button to set the time.
7. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
8. Press the Escape button to exit.
pump menu descriptions are as follows:
®
system. The default pump address is #1. When connected to IntelliPool
®
the pump only communicates with address #1.
®
pumps cannot be connected in series with other pumps.
®
system time. The IntelliFlo
®
pump is connected via the RS-485 COM port
®
system clock controls all scheduled
®
will retain the time memory for 96 hours before
®