4
IMPORTANT PUMP WARNING AND SAFETY INSTRUCTIONS
IMPORTANT NOTICE
This document is subject to change without notice.
Trademarks and disclaimers: Pantera™ UltraFlow®,
WhisperFlo®, SuperFlo®, Sta-Rite® and Pentair are
trademarks and/or registered trademarks of Pentair
and/or its affiliated companies. Unless noted, names
and brands of others that may be used in this document
are not used to indicate an affilitation or endorsement
between the proprietors of these names and brands and
Pentair. Those names and brands may be the trademarks
of those parties or others.
Attention installer: This guide contains important
information about the installation, operation and safe use
READ, FOLLOW AND SAVE THESE INSTRUCTIONS!
This is the safety alert symbol. When you see this symbol on your system or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
Warns about hazards that can
WARNING
cause death, serious personal
injury or major property damage if
DANGER
ignored.
Warns about hazards that may or
CAUTION
can cause minor personal injury or
property damage if ignored.
When installing and using this electrical equipment, basic safety precautions should always be followed, include the
following:
Children should not be allowed to
WARNING
play with the appliance.
WARNING
RISK OF ELECTRICAL SHOCK
The pump must only be connected to sockets that have
been installed properly in accordance with the regulations
and are protected with a FI-safety switch (RCD,30mA).
WARNING
CONNECT TO SUPPLY CIRCUIT
This unit must be connected only to a supply circuit that
is protected by a RCD. Such a RCD should be provided
by the installer and should be tested on a routine basis.
To test the RCD, push the test button. The RCD should
interrupt power. Push the reset button. Powers should be
restored. If the RCD fails to operate in this manner, the
RCD is defective. If the RCD interrupts power to the pump
without the test button being pushed, a ground current
is flowing, indicating the possibility of an electric shock.
Do not use this pump! Disconnect the pump and have the
problem corrected by a qualified service representative
before using.
Single speed pumps Installation and User' s Guide
of this product. This information should be given to the
owner and/or operator of this equipment after installation
or left on/near the pump.
Attention user: This manual contains important
information that will help you in operating and maintaining
this product. Please retain it for future reference.
Warnings and safety instructions for Pentair Aquatic
Systems pumps and other related products are available
at: www.pentairpooleurope.com
NOTE: Indicates special instructions not related to
hazards.
Carefully read and follow all safety instructions in this
manual and on equipment. Keep safety labels in good
condition; replace if missing or damaged.
This pump is for use with permanent
CAUTION
swimming pools and may also be
used with hot tubs and spas if so marked. Do not use with
storable pools.
A permanently installed pool is constructed in/on the
ground or in a building such that it cannot be readily
disassembled for storage.
A storable pool is constructed so that it is capable of
being readily disassembled for storage and re-assembled
to its original integrity.