Troubleshooting - Mobicool MCF 32 Instructions De Montage Et De Service

Troubleshooting

 A reason for the claim or description of the fault
Note that self-repair or nonprofessional repair can have safety consequences
and might void the warranty.
9 Troubleshooting
Fault
The cooling device
does not function,
"POWER" LED does not
glow.
The cooling device
does not cool (plug is
inserted, "POWER" LED
is lit).
The cooling device
does not cool (plug is
inserted, "POWER" LED
flashes orange, dis-
play is switched off).
When operating from
the DC power socket:
The ignition is on and
the cooling device is
not working and the
"POWER" LED is not lit.
The display shows an
error message (e.g.
"Err1") and the cooling
device does not cool.
18
MCF32, MCF40, MCF60, FR40 AC/DC
Possible cause
There is no voltage
present in the DC power
socket in your vehicle.
Defective compressor.
Voltage of the vehicle
battery is too low.
The DC power socket is
dirty. This results in a
poor electrical contact.
The fuse of the DC plug
has blown.
The vehicle fuse has
blown.
The cooling device has
switched off due to an
internal fault.
Suggested remedy
The ignition must be switched on in most
vehicles to apply current to the DC power
socket.
This can only be repaired by an
authorized customer services unit.
Test the vehicle battery and charge it as
needed.
If the plug of your cooling device
becomes very warm in the DC power
socket, either the DC power socket must
be cleaned or the plug has not been
assembled correctly.
Replace the fuse (8 A) in the DC plug, see
chapter "Replacing the fuse" on page 17.
Replace the vehicle's DC power socket
fuse (usually 15 A). Please refer to your
vehicle's operating manual.
This can only be repaired by an
authorized repair center.
EN