Mounting The Inverter - SMA SUNNY TRIPOWER 60 Instructions D'installation

SMA Solar Technology AG / SMA Solar Technology America LLC
INFORMATION
Use of the wall mounting bracket delivered with the
inverter is mandatory. Warranty claims will expire if
the inverter is operated without the wall mounting
bracket. It is strongly recommended to use all six
mounting holes.
Mounting of the wall mounting bracket:
• Mount the wall mounting bracket in the designated
area.
• Use screws and wall plugs that can safely carry the
weight of the inverter.
• Ensure that the mounting plate is correctly aligned.
• When installing one or several inverters, observe the
safety clearances to ensure sufficient airflow.
Clearances are specified in figure 2.8 and on the
mounting plate label.
• Mounting multiple inverters side by side in a single row
is recommended. Contact the supplier for guidelines
when mounting inverters in more than one row.
• Ensure adequate clearance at the front, for safe
installation and service access to the inverter.
Figure 2.10 Mounting of the wall mounting bracket
Installation Guide

2.3 Mounting the Inverter

When handling the inverter observe the local health and
safety regulations.
Procedure:
1. Lift the inverter. Locate the slots on the side of the wall
mounting bracket. Use M12 or ½ in lifting bolts and
matching nuts (not included in the scope of delivery).
Figure 2.11 Position the inverter
Figure 2.12 Lifting bolts
2 Installation
STP60-10-IA-xx-11 23