Maintenance - SMA SUNNY TRIPOWER 60 Instructions D'installation

SMA Solar Technology AG / SMA Solar Technology America LLC
Events Caused by the Self-Test
ID Description
100 PV input current is negative. Sensor fault. Check the polarity of the PV system. If
264, 266 Measurement circuit test failed.
272 PV overvoltage protection device error.
Inverter will continue operation without
overvoltage protection.
273 Grid overvoltage protection device error.
Inverter will continue operation without
overvoltage protection.
274 Overvoltage protection device status
unknown.
350– Residual-current monitoring unit (RCMU)
352 self-test failed.
353 Current sensor test failed.
356– Transistor and relay test failed or inverter
361 relay has failed (contact assumed
welded).
366 Residual-current monitoring unit (RCMU)
self-test failed.
Table 4.5 Events caused by the self-test

4.2 Maintenance

Ensure that the heat sink at the rear of the inverter is not
covered.
Clean the contacts of the PV load-break switch once a year.
Clean by cycling the switch to on and off positions ten times.
The PV load-break switch is located at the bottom of the
inverter.
For correct operation and a long service life, ensure free air
circulation for the following areas:
• around the heat sink at the top and side of the inverter
where the air exhausts, and
• towards the fan at the inverter base.
To clear obstructions, clean using compressed air, a soft
cloth, or a brush.
The temperature of the heat sink can exceed 70°C.
Installation Guide
Measure
polarity is correct, call Service.
Restart the inverter. If the event persists,
call Service.
Replace PV overvoltage protection
device. See SPD replacement instructions
for details.
Replace PV overvoltage protection
device. See SPD replacement instructions
for details.
Restart the inverter. If the event persists,
call Service.
Contact Service.
Contact Service.
Contact Service.
Contact Service.
4 Service
DNO SMA
Service
Line
- x -
- x -
- x -
- x -
- x -
- x -
- x -
- x -
- x -
STP60-10-IA-xx-11
PV
37