Inspecting Components - Mustang Survival KHIMERA PFD Manuel Du Propriétaire

INSPECTING COMPONENTS

Before each use, check your flotation device for readiness:
1. At the front
bottom of the
device, open the
Velcro™ fastener
tapes and expose
the inflator and
cylinder assembly
by flipping out the
labels.
2. Unscrew and
remove the CO
2
gas cylinder from
the inflator and
inspect its small
end. Is the cylinder
pierced?
3. Inspect the
inflator's metallic
lever. Is the lever in
the up-and-ready
position with the
green indicator pin
in place over the
lever?
If your cylinder is pierced or your lever is not in the up-and-ready
position with the green indicator pin in place, you will need to re-arm
your flotation device (see Re-arming, p. 12) before continuing.
6
FIGURE 2
OK
Solid
Cylinder
Top
FIGURE 3
OK
FIGURE 4
FOLD UP
Pierced
Cylinder
Top
STOP