Mustang Survival KHIMERA PFD Manuel Du Propriétaire page 15

3. Remove the empty cylinder.
4. Re-install the pull handle.
5. Check the manual inflation system to determine that the lever arm
and piercing pin move freely when moving the lever (attached
to the pull tab) several times down and up. There should be no
binding of mechanical parts.
6. Position lever arm down. Insert green pin.
ENSURE LEVER ARM IS DOWN
AND HOLES ALIGNED
7. Install new cylinder. Hand-tighten.
There is a second elastic keeper in the inflator area, meant to hold a
second 12g CO cylinder (not supplied).
2
8. Tuck the labels back in, over the inflation assembly, and close the
Velcro ™ tapes at the bottom of the device.
OK
GREEN PIN
FRAGILE
FIGURE 16
FIGURE 17
FIGURE 18
OK
FIGURE 19
OK
FIGURE 20
13