Omron MicroAIR U100 Mode D'emploi page 23

How to disinfect the parts
„Disinfection by commercially available disinfectant
Use a commercially available disinfectant. Follow the instructions provided by
the disinfectant manufacturer.
Note: Never clean with benzene or thinner.
• Vibrating element and its surrounding
Soak the vibrating element and the area around the vibrating element
in disinfectant.
• Medication Container, Mouthpiece, Mesh Cap, Mask Adapter and Mask
Soak the parts in disinfectant.
„Disinfection by boiling
• Medication Container, Mouthpiece, Mesh Cap, Mask Adapter
and Mask (SEBS) (Optional)*
Parts may be boiled between 15 to 20 minutes.
After boiling, carefully remove the parts, shake off excess water and
allow to air dry in a clean environment.
*1 An example of commercially available disinfectant. (The concentration and residence time specified in the table
are under the conditions where the service life of the parts is tested with each disinfectant used as described in its
instruction manual. Please note that the testing was not performed for the purpose of ensuring the effectiveness
of the disinfectants. There is no intention of suggesting that such disinfectants be used. Conditions of use and
ingredients of disinfectant vary for manufacturers. Please read the instruction manuals carefully before use and
apply disinfectant to each part in an appropriate way. Please notice that service life of the parts may be shorter
depending on conditions, environments and frequency of use.)
*2 Remove the rubber band from mask before disinfecting.
*3 The mask is phthalate free.
*4 The band is not made with natural rubber latex.
2
EN
23