How To Use Pc Software - Chauvin Arnoux CA 650 Notice De Fonctionnement

To set up PC software Observer I & II, it is required to key in IP address of recorder.
This IP address can be found in 4.8 System Info mode under Configuration.
The configuration of Real-time Viewer is set for PC. This is different from the
configuration of Historical Viewer which is the same as the recorder.
5.6.

How to use PC software

After installing the PC basic software, Observer I, the user may find the two parts
Configuration and Historical Viewer. The extensive software Observer II is in three parts
Configuration, Real-time Viewer, Historical Viewer.
Configuration: Enter Configuration, click the icon New
key in the new project name, and then choose CF card or Ethernet.
a. For CF card, click the icon File
question appears - Do you want to receive configuration data now?
confirmation, the user needs to save configuration and Dump measured data from
the recorder to CF card, then insert CF card to CF reader connected with PC.
After confirmation, the PC will receive configuration from the CF card. In the
configuration table, the user may review configuration by clicking the icons of
Channel , Display
This configuration is used by the Historical Viewer to read historical data and trend.
If necessary, the user may change configuration on PC and Send configuration
to CF card, then Load it to the recorder. Anytime, the configuration of the recorder
is changed, the PC can Receive configuration
b. For Ethernet, click the icon File
question appears - Do you want to receive configuration data now?
confirmation, PC will receive configuration from recorder via Ethernet.
configuration table, the user may review the configuration by clicking the icons of
Channel , Display
necessary, the user may change the configuration on the PC and Send
configuration
read historical data and trend.
Historical Viewer: Enter into Historical Viewer, open the project set under
Configuration as above.
Click the icon Import Measured Data
the CF card or from recorder via Ethernet. After importing procedure, a trend will be
displayed.
, Tools
, Tools , Instrument
to recorder. This configuration is used by the Historical Viewer to
, and select the file path of the CF card. A
, Instrument and System Information
from the recorder via CF card.
, then key in the IP address of recorder. A
and System Information
to make the PC import measured data from
95
for a new project,
Before
.
After
In the
. If