Clock - Chauvin Arnoux CA 650 Notice De Fonctionnement

IR detector: Enables the infrared technology on recorder is an innovative idea to
prolong the lifetime of LCD display. The Infrared detector works with the Screensaver
to protect the LCD. The Infrared detector senses the movement of body temperature
when a user gets closer or walks away. (Range approximately 2 meters). Operation is
as follows: Set the IR Sensor to On and Screensaver at 1 Min. Display will turnoff in 1
minute after the user walks away from the recorder. Once the Infrared detector senses
heat movement within 2m of the recorder, display turns on straight away, without
needing to press any key on the recorder.
Note:
♦ IR( Infrared ) detector needs to work together with Screensaver, it cannot function
alone. However, the Screensaver can function alone after the IR Sensor is disabled.
Communication
PCTransfer: Selects RS-232/RS-485/RS-422, or standard Ethernet communication.
RS-232, RS-485, RS-422:
Address: 0 to 247 nodes for RS-485
Baud Rate: Selects it from various Baud rates 1200, 2400, 4800, 9600, 19200, 38400,
57600 or 115200.
Data Format: Selects it from three different data formats.
Ethernet:
IP: Select Automation if the server on the network automatically allocates the IP
address for the recorder. Select User Define to manually set a fixed address for the
recorder. Two new columns will appear for keying in fixed addresses
IP Address: Defines the correct address of the recorder on the network
Subnet Mask: Defines the correct SubnetMask address on the network
Default Gateway: Different Gateway has different IP address on Ethernet.
Note:
If Automation is selected, the IP address and SubnetMask are invisible. IP address can
be found in 4.8 System Info mode under Configuration. Because IP address might be
reallocated with new address by the server after power off and on, the user
defining fixed addresses is recommended.
4.5.

Clock

Press Back key, to return to the beginning of Configuration mode. Selects Clock then
presses the Enter key to get into Clock ( Date/Time ) mode to set up the local time.
Date Style: Selects either month/date/year or date/month/year
Date/Time: Set up the local time. Use directional keys going to the Apply column, then
press the Enter Key to apply it to the recorder.
90